
connecting the Benwin LTS
speakers to your computer
9
8
1
2
3
4
5
6
7
8
9
Turn the volume on the
speakers all the way down.
Turn on your computer and
play your favorite music or audio.
Adjust the volume on your speakers
to a comfortable level. If there is no
sound, check the volume control
and all the connections.
If this still does not work, see
“Section titled: Troubleshooting”
NOTE: BE SURE TO TEST YOUR SPEAKERS
WITH YOUR COMPUTER MICROPHONE ON
(REFER TO THE DOCUMENTATION THAT COMES
WITH YOUR COMPUTER). IF THE SPEAKERS ARE
PLACED TOO CLOSELY TO THE MICROPHONE,
THEY WILL PRODUCE A HOWLING SOUND
(FEEDBACK). TO AVOID THIS SITUATION, WITH
THE MICROPHONE ON, TURN THE VOLUME
OF THE SPEAKERS ALL THE WAY UP AND HOLD
THEM WHERE YOU PLAN TO MOUNT THEM.
IF YOU HEAR A HOWLING SOUND, MOVE
THE SPEAKERS TOWARDS THE BACK OF THE
MONITOR. THIS ELIMINATES THE HOWLING
SOUND BY PLACING THE SPEAKERS
FARTHER AWAY FROM THE MICROPHONE.
Follow these steps to connect the speakers
to your computer. Refer to the following
illustration for identification.
Determine where the line out jack is on your
computer. Normally there are several ports
on the back of your computer. Refer to the
owner’s manual for the computer to determine
location. If the plug supplied does not fit, it is
not a stereo mini-plug. There f o re , you must use
an appropriate adapter. If a line out jack is
unavailable, use the headphone jack.
Turn off your computer or stereo system.
Plug one end of the stereo mini-plug
cable to the line out jack of the computer.
Plug the other end of the stereo mini
plug cable into the line-input jack of
the right speaker.
Plug one end of the second mini-plug cable
into the right speaker line output jack and
plug the other end into the left speaker
line input jack
Connect the power adapter to the 12 V DC
power input of the right speaker, and then
plug the adapter into a power outlet.
final instruction manual 7/14/01 11:42 AM Page 10
Kommentare zu diesen Handbüchern